Living For Sailβίντεο
This Changes EVERYTHING!… Turning Our Bed Into a King | DIY Sailboat Refit
5 Απριλίου 2026 · 20 λεπτά · 10K προβολές
Τι καλύπτει αυτό το βίντεο
On a 1989 Liberty 458 named Antidote, John strips all cabinetry from both port and starboard sides of the aft cabin to convert a queen-sized berth into an approximately 80-by-80-inch king-sized sleeping platform.0:02 Only 31 Liberty 458s were built, and John documents that at least one left the factory with this exact layout; fellow owners Jake and Jackie confirm 51 inches across the stern is enough to sleep comfortably lengthwise.8:38 A seven-inch foam mattress, which can be rolled or compressed for installation, is calculated to achieve that 51-inch minimum at the transom.9:09 John addresses headroom loss — currently six to seven inches with no mattress — and plans to raise the platform height to gain width at the hull's narrowing stern.9:09 Storage concerns drive several design decisions: full-extension drawer slides will replace the buried corner step-boxes, small benches on each side will substitute as steps into the bunk, and a gas-shock lift-up platform over the steering gear is under consideration to open the large under-berth space.12:22 Curved teak trim pieces on the transom, bedded in 5200, are removed with heat and a knife; one section reveals a quarter-inch wedge gap indicating a poor original fit.14:40 Raising the mattress platform height is the key variable controlling both usable bed width and remaining headroom in a tapered stern.
Σκάφη σε αυτό το βίντεο
Περισσότερα από το Living For Sail
Από Living For Sail — δείτε το σκάφος του καναλιού, το πλήρωμα και κάθε αναλυμένο βίντεο.
The Sailing Directory Newsletter
Ένα email με τις καλύτερες ανακαλύψεις του στόλου — τις στιγμές, τα σκάφη και τις ιστορίες που αξίζουν τον χρόνο παρακολούθησής σας. Εισάγετε τη διεύθυνσή σας για να λάβετε το δικό σας αντίγραφο.