RAN Sailing · βίντεο

Τι καλύπτει αυτό το βίντεο

Building custom shaker-style teak doors for a one-off sailboat interior requires precise joinery and veneer work to match existing Burma teak. To construct the door frames, the builder uses a router bit kit with bearing-guided bits to cut grooves for the center panels, opting for a manual setup over a router table to avoid lengthy calibration.5:33 Because standard teak plywood veneers do not match the boat's older teak, the builder creates custom panels by vacuum-bagging 1.5mm teak veneers onto 4.5mm plywood.16:32 To achieve a book-matched grain pattern, the builder planes the edges of the veneers to ensure a tight seam, tapes the joint with painter's tape to prevent epoxy bleed-through during the vacuum process, and bonds the assembly with epoxy.20:39 The finished doors are stored until the closet structure is complete to allow for final fitting and adjustments.26:43 The project prioritizes a simple, Scandinavian-inspired aesthetic to balance high-quality finish with the practical need to complete the interior build.

Περισσότερα από το RAN Sailing

This Is Where Boat Builds Break People - Ep. 501 Ran SailingΑυγ 2026Our 52ft Sailboat Build Reaches Another Milestone! - Ep. 500 Ran SailingΑυγ 2026How Many Hatches Does a 52ft Sailboat Need? - Ep. 499 Ran SailingΑυγ 2026Making Our Sailboat One Solid Structure - Ep. 498 Ran SailingΑυγ 2026

Από RAN Sailing — δείτε το σκάφος του καναλιού, το πλήρωμα και κάθε αναλυμένο βίντεο.

The Sailing Directory Newsletter

Ένα email με τις καλύτερες ανακαλύψεις του στόλου — τις στιγμές, τα σκάφη και τις ιστορίες που αξίζουν τον χρόνο παρακολούθησής σας. Εισάγετε τη διεύθυνσή σας για να λάβετε το δικό σας αντίγραφο.