The On Deck Channel · βίντεο

Τι καλύπτει αυτό το βίντεο

Drilling through a cored fiberglass deck — two layers of fiberglass sandwiching a foam or plywood core — requires an oversized hole filled with thickened epoxy before the final fastener hole is drilled.0:03 Ryan demonstrates the technique used when mounting solar panel brackets on the boat's stack: drill a pilot hole, then drill an oversized hole (e.g., a 5/8- or 3/4-inch hole for a 5/16-inch fastener), tape the underside to capture epoxy, inject 3M 610 thickened epoxy from the top, wipe flush, and let it cure 24 hours.2:04 The next day, drill the final, smaller center hole through the cured epoxy plug, then through-bolt with CT1 adhesive sealant.2:13 The epoxy plug serves two purposes: it prevents water from reaching the core if sealant fails, and it acts as a compression stop so over-tightening cannot crush the core or crack the gelcoat.1:00 For solid fiberglass (no core), the epoxy plug is unnecessary; the critical step instead is countersinking the hole so side-loading from the fastener does not crack the gelcoat and so sealant can seat properly around the fastener head.3:10

Περισσότερα από το The On Deck Channel

This is My Favorite Upgrade on a Boat... | Leopard 50Οκτ 2026Get a Boat They Said... It Will Be Fun | New to Boat Life SeriesΣεπ 2026First Time Sailing... Failed | New to Boat Life SeriesΣεπ 202624 shipping containers. A lot more than rigging!Αυγ 2026

Από The On Deck Channel — δείτε το σκάφος του καναλιού, το πλήρωμα και κάθε αναλυμένο βίντεο.

The Sailing Directory Newsletter

Ένα email με τις καλύτερες ανακαλύψεις του στόλου — τις στιγμές, τα σκάφη και τις ιστορίες που αξίζουν τον χρόνο παρακολούθησής σας. Εισάγετε τη διεύθυνσή σας για να λάβετε το δικό σας αντίγραφο.