Catamaran Mistertong · βίντεο

Τι καλύπτει αυτό το βίντεο

Djé and Nad, aboard their Outremer catamaran hauled out in the Caribbean, rebuild one of the boat's transoms (jupes) from scratch using fiberglass lamination. The work centers on fabricating and bonding a new structural panel to replace rotted and damaged sections, shaping rounded edges for aesthetics and dinghy-boarding access, then laying four layers of 450g/m² fiberglass cloth — nearly 2 kg/m² total — over the prepared surface.11:00 Djé fills voids with loaded epoxy before laminating to ensure full adhesion.19:42 He also applies Loctite 577 thread-sealant to refit seacocks on the saildrive units, replacing an unsuitable jointing paste that had left the valves loose; he plans a 48-hour cure check.2:40 In the port engine bay, a bilge pump hose had come unglued; he rebonds it with 6K tape but cannot do the same in the starboard bay due to residual water, likely entering through the tiller hatch.3:53 A sourcing problem with peel ply surfaces mid-job: a locally purchased fabric turns out to be taffeta rather than peel ply and cannot be removed after cure, making re-lamination over it unreliable.27:04 Thorough preparation — pre-cutting all cloth, staging materials, and shaping surfaces before mixing resin — is the key factor in a successful lamination session.28:25

Περισσότερα από το Catamaran Mistertong

#250 I'm refused because of my outfit ...Σεπ 2026#249 The burden of paperwork ...Αυγ 2026#248 Despite the work, we're having a good time with friends ..Αυγ 2026#247 We're getting our driver's licenses...Αυγ 2026

Από Catamaran Mistertong — δείτε το σκάφος του καναλιού, το πλήρωμα και κάθε αναλυμένο βίντεο.

The Sailing Directory Newsletter

Ένα email με τις καλύτερες ανακαλύψεις του στόλου — τις στιγμές, τα σκάφη και τις ιστορίες που αξίζουν τον χρόνο παρακολούθησής σας. Εισάγετε τη διεύθυνσή σας για να λάβετε το δικό σας αντίγραφο.