Salt & Tar · βίντεο

Τι καλύπτει αυτό το βίντεο

Garrett builds a 10-foot Chesapeake Light Craft (CLC) Tenderly dinghy from plans rather than a pre-cut kit.8:02 The project requires manual lofting and cutting of plywood components, including five frames, a skeg, and a daggerboard trunk.3:41 Each frame consists of a three-layer "sandwich" made of a middle section and two outer doublers, which must be glued and aligned precisely to prevent hull distortion.5:37 Because the plans provide only half-frame templates, Garrett uses these as patterns to cut the remaining halves.5:34 He manages alignment during the epoxy glue-up by using CA glue to tack-weld temporary scrap wood to the frame halves, ensuring the butt joints remain square.14:41 He also uses small stainless steel tack nails as locator pins to keep the slippery, epoxy-coated layers from shifting while clamping.15:19 The build process involves seven sheets of plywood and requires careful transfer of stitch-hole locations from the primary frame pieces to the doublers.9:19

Περισσότερα από το Salt & Tar

Meet Victoria - Tour of our William Garden 'Porpoise' built by Robin Fung in 1975Οκτ 2026Salt & Tar: Ep.360- Good NewsΟκτ 2026Salt & Tar: Ep.359- Memory LaneΣεπ 2026Salt & Tar: Ep.358- Sad NewsΣεπ 2026

Από Salt & Tar — δείτε το σκάφος του καναλιού, το πλήρωμα και κάθε αναλυμένο βίντεο.

The Sailing Directory Newsletter

Ένα email με τις καλύτερες ανακαλύψεις του στόλου — τις στιγμές, τα σκάφη και τις ιστορίες που αξίζουν τον χρόνο παρακολούθησής σας. Εισάγετε τη διεύθυνσή σας για να λάβετε το δικό σας αντίγραφο.