Sampson Boat Co · βίντεο

Τι καλύπτει αυτό το βίντεο

Leo Goolden installs two tri-ducer transducers through the hull of Tally Ho, a wooden gaff cutter hauled out at a boatyard in Panama.0:11 The primary transducer had failed weeks earlier; removing it proved difficult because 3M 4200 sealant bonded the fairing block to the hull over a large surface area, ultimately requiring the fairing block to be destroyed before the bronze body could be twisted free.1:37 The replacement transducer connects directly to navigation software on a PC rather than the boat's NMEA 2000 network, so Leo cuts a second hole in the port side to install a NMEA 2000-compatible tri-ducer, giving depth readouts on cockpit displays and providing redundancy.9:05 Shaping the fairing block for the port transducer requires a compound bevel cut; with no adequate bandsaw in the yard, Leo cuts it by hand using cardboard guidelines, then uses the two halves as both the external fairing block and the internal backing block.11:01 Both transducers are wired and sealed but cannot be tested until the boat re-enters the water.17:12 The episode also covers the cove line being painted metallic gold over a yellow undercoat to mask future wear.0:11

Περισσότερα από το Sampson Boat Co

Tally Ho sails into England after 59 years overseas!Αυγ 2026A very brief update from the Fal estuaryΑυγ 2026Piracy and Peril - stories from the boatyards of West CorkΑυγ 2026Tally Ho completes her Atlantic Crossing at the Fastnet Rock!Αυγ 2026

Από Sampson Boat Co — δείτε το σκάφος του καναλιού, το πλήρωμα και κάθε αναλυμένο βίντεο.

The Sailing Directory Newsletter

Ένα email με τις καλύτερες ανακαλύψεις του στόλου — τις στιγμές, τα σκάφη και τις ιστορίες που αξίζουν τον χρόνο παρακολούθησής σας. Εισάγετε τη διεύθυνσή σας για να λάβετε το δικό σας αντίγραφο.