Sailing Good, Bad, and Ugly · video

Hva denne videoen dekker

Matt and Kristen frame a new interior wall in their home, extending the structure to meet 13-foot vaulted ceilings.9:51 To determine the precise ceiling pitch for the top plate, Matt uses a plumb bob and a speed square to calculate a 49.5-degree angle, which he then transfers to a miter saw.12:29 He anchors the top plate by locating ceiling trusses through the drywall, drilling pilot holes, and fastening the lumber directly to the structural members.12:51 To maintain consistent stud cuts at a 16.3-degree angle, he uses a scrap board as a template to lock the miter saw setting, allowing for rapid, repeatable cuts.22:28 The project involves repurposing old lumber for framing, which requires careful inspection to avoid bowed or knotted boards that could compromise the final drywall finish.20:21 Matt also fabricates a custom GoPro mount using a drill press and a spare clamp to improve filming angles for the ongoing renovation.24:03

Mer fra Sailing Good, Bad, and Ugly

We Needed a Win and This Wasn’t Itaug. 2026The End Is Finally Nearaug. 2026We've Been Avoiding This and We Can't Anymoreaug. 2026We Were Not Ready For This Outcome!aug. 2026

Fra Sailing Good, Bad, and Ugly – se kanalens båt, mannskap og alle analyserte videoer.

The Sailing Directory Newsletter

Én e-post med flåtens beste funn – øyeblikkene, båtene og historiene som er verdt din seertid. Skriv inn din egen adresse for å få din egen kopi.