Sailing Uma · video

Hva denne videoen dekker

Dan and Kika reattach the keel to their sailboat, Uma, following an extensive structural refit. After vacuum-bagging the keel stub with new fiberglass, the crew redrilled the keel bolt holes to accommodate the increased thickness of the hull and G10 reinforcement.▶ 4:25 To ensure precise alignment, they leveled the boat on jack stands and used levers to center the keel, as the lack of a long guide stud necessitated a manual dry-fit process.▶ 13:04 They applied a high-strength, low-viscosity epoxy to the joint, using a foam dam to contain the squeeze-out.▶ 20:59 Once the keel was positioned, they secured the nuts and washers from the bilge, lifting the boat slightly to allow the keel to hang freely and settle into its final vertical orientation.▶ 22:08 After the epoxy cured, the crew faired the joint with filler and applied primer to finish the repair.▶ 34:34 The project successfully restored the structural integrity and stiffness of the keel connection.

Mer fra Sailing Uma

We Owe You The Full Storyjuli 2026We Covered Our Boat in Solar. Is It Enough? | Step 492 (Part 3)juli 2026Uma is Ready to Launch! (But there's a catch) | Step 489juni 2026How Many Sails Does it Take To Replace a Diesel Engine? | Step 488mai 2026

Fra Sailing Uma – se kanalens båt, mannskap og alle analyserte videoer.

The Sailing Directory Newsletter

Én e-post med flåtens beste funn – øyeblikkene, båtene og historiene som er verdt din seertid. Skriv inn din egen adresse for å få din egen kopi.