Carpe Diem Sailing · video

Hva denne videoen dekker

Marco demonstrates the process of removing and replacing a knotmeter transducer while the boat remains in the water.0:03 He first unscrews the locking ring on the transducer housing and prepares a dummy plug to minimize water ingress.1:19 Upon pulling the transducer, a small, manageable amount of water enters the hull during the few seconds required to swap the unit for the dummy plug.1:26 The transducer's paddlewheel was fouled with small mussels, preventing it from spinning.1:42 After cleaning the paddlewheel, he repeats the swap process to reinstall the transducer, ensuring it is aligned correctly.2:26 He uses a Surehold PVA sponge and a chamois to soak up the water that entered the bilge during the procedure.2:01 The bilge pump activates to clear the remaining water.2:58 This demonstration shows that while the process causes initial anxiety, the volume of water entering the boat is limited and controllable with proper preparation.

Mer fra Carpe Diem Sailing

Ep 55: Gybing Single Handedjan. 2023Ep 44: Coming About Single Handednov. 2021Ep 37: Navigation: Basic Plotting Part 1juni 2021Ep 31: How to Dress for Sailing in Any Weathermars 2021

Fra Carpe Diem Sailing – se kanalens båt, mannskap og alle analyserte videoer.

The Sailing Directory Newsletter

Én e-post med flåtens beste funn – øyeblikkene, båtene og historiene som er verdt din seertid. Skriv inn din egen adresse for å få din egen kopi.