Pacific Yacht Systems · βίντεο

Τι καλύπτει αυτό το βίντεο

Fabricating heavy-duty battery jumpers requires precise cable preparation, proper crimping techniques, and correct hardware stacking to ensure electrical conductivity. When working with 2-0 gauge cable, measure the required length to allow for gentle, even bends rather than tight angles.1:37 Strip the insulation carefully to avoid cutting wire strands, then twist the cable strands to match their natural lay before inserting them fully into the lug.3:52 Use a battery crimper with the appropriate die set—such as E and A for 2-0 cable—and perform two separate crimps to ensure full compression.5:43 Apply heat shrink tubing over the connection, ensuring it does not cover the flat contact surface of the lug.8:36 When installing the finished cable, stack hardware so that stainless steel components, which are poor conductors, remain on the outside of the connection.12:16 Pre-preparing cables outside of confined spaces like lazarettes or bilges improves accuracy and leverage.6:47 Always verify that all terminal connections are tightened before applying power to the system.11:56

Περισσότερα από το Pacific Yacht Systems

There Is NO MORE ROOM For Additional Batteries, What Do You Do? PYS Tech TalkΣεπ 2026DIY vs Professional Boat Electronics, What to Look for When Buying Used - PYS Tech TalkΑυγ 2026When Battery Charging Through An Inverter Might Make Sense - PYS Tech TalkΑυγ 2026Upgrading Your Alternator? These Are OUR Top Tips - PYS Tech TalkΑυγ 2026

Από Pacific Yacht Systems — δείτε το σκάφος του καναλιού, το πλήρωμα και κάθε αναλυμένο βίντεο.

The Sailing Directory Newsletter

Ένα email με τις καλύτερες ανακαλύψεις του στόλου — τις στιγμές, τα σκάφη και τις ιστορίες που αξίζουν τον χρόνο παρακολούθησής σας. Εισάγετε τη διεύθυνσή σας για να λάβετε το δικό σας αντίγραφο.