BoatworksToday · βίντεο

Τι καλύπτει αυτό το βίντεο

Achieving a high-gloss marine finish requires a conventional high-volume, high-pressure spray system rather than HVLP or turbine setups, which often lack the pressure needed to atomize marine paints properly.3:10 Andy of Boatworks Today utilizes a DeVilbiss JGA 510-765 spray gun with a 1.1mm needle, paired with a two-quart Binks pressure pot.3:54 This setup requires significant air volume, ideally supplied by a compressor capable of at least 16 CFM, though a 3-horsepower unit with a 60-gallon tank serves as a bare minimum.4:47 To maintain consistent pressure at the gun—typically 45 PSI for primers and 60–65 PSI for paints—shorter air hoses are necessary to minimize pressure drop.6:39 Because overspray is inevitable in large-scale boat painting, effective ventilation requires a balanced air exchange system that pulls fumes out while pumping in fresh, heated air.7:35 For environments prone to dust, choosing a paint that allows for wet sanding and buffing, such as Awlcraft 2000, is essential for achieving a mirror finish.11:39

Περισσότερα από το BoatworksToday

I Was Wrong About My Boat's Victron Wiring (You Were Right!)Σεπ 2026Will This Entire Victron Electrical System Fit In My Little Boat?Αυγ 2026The Primer Mistake You're Probably Making Painting Your Boat: Film Thickness, Not Smoothness!Αυγ 2026V-Berth Electrical Layout On A Small Sailboat: It's Tight, But It Should Work!Αυγ 2026

Από BoatworksToday — δείτε το σκάφος του καναλιού, το πλήρωμα και κάθε αναλυμένο βίντεο.

The Sailing Directory Newsletter

Ένα email με τις καλύτερες ανακαλύψεις του στόλου — τις στιγμές, τα σκάφη και τις ιστορίες που αξίζουν τον χρόνο παρακολούθησής σας. Εισάγετε τη διεύθυνσή σας για να λάβετε το δικό σας αντίγραφο.