Sailing Uma · βίντεο

Τι καλύπτει αυτό το βίντεο

The crew of the 40-foot sailboat Uma performs structural integrity tests on their hull refit after a test laminate sample delaminated unexpectedly. During the initial fiberglassing phase, the team used vinyl ester resin and peel ply to reinforce the hull with ribs and stringers.1:10 When a replica test piece failed a hammer impact test by popping off in a clean sheet, the crew feared the structural bonds inside the actual hull were compromised.1:36 After consulting with professional boat builders, they identified surface contamination and lack of mechanical keying as potential causes.2:23 The crew conducted a series of controlled tests on new samples, comparing bonding methods including cleaning with acetone, grinding with 80-grit sandpaper, and using peel ply alone.12:06 They also stress-tested the actual hull by striking it with a hammer through a block of wood, confirming no delamination occurred on the boat itself.6:36 The experiments proved that cleaning with acetone followed by grinding to create a rough surface provides a superior mechanical bond compared to laminating directly over peel ply.15:37 Proper surface preparation, specifically grinding to open fibers, ensures structural integrity in fiberglass repairs.

Περισσότερα από το Sailing Uma

We're Finally Setting Sail Again!Σεπ 20264 Hours to Rig Solar for an 8-Month Solo CircumnavigationΣεπ 2026Solar Sponsor Backed Out Before Sailing Around the World !Σεπ 2026Our boat won’t look the same after this | Step 495Αυγ 2026

Από Sailing Uma — δείτε το σκάφος του καναλιού, το πλήρωμα και κάθε αναλυμένο βίντεο.

The Sailing Directory Newsletter

Ένα email με τις καλύτερες ανακαλύψεις του στόλου — τις στιγμές, τα σκάφη και τις ιστορίες που αξίζουν τον χρόνο παρακολούθησής σας. Εισάγετε τη διεύθυνσή σας για να λάβετε το δικό σας αντίγραφο.