Sailing Uma · video

Hva denne videoen dekker

The crew of the 40-foot sailboat Uma performs structural integrity tests on their hull refit after a test laminate sample delaminated unexpectedly. During the initial fiberglassing phase, the team used vinyl ester resin and peel ply to reinforce the hull with ribs and stringers.1:10 When a replica test piece failed a hammer impact test by popping off in a clean sheet, the crew feared the structural bonds inside the actual hull were compromised.1:36 After consulting with professional boat builders, they identified surface contamination and lack of mechanical keying as potential causes.2:23 The crew conducted a series of controlled tests on new samples, comparing bonding methods including cleaning with acetone, grinding with 80-grit sandpaper, and using peel ply alone.12:06 They also stress-tested the actual hull by striking it with a hammer through a block of wood, confirming no delamination occurred on the boat itself.6:36 The experiments proved that cleaning with acetone followed by grinding to create a rough surface provides a superior mechanical bond compared to laminating directly over peel ply.15:37 Proper surface preparation, specifically grinding to open fibers, ensures structural integrity in fiberglass repairs.

Mer fra Sailing Uma

We're Finally Setting Sail Again!sep. 20264 Hours to Rig Solar for an 8-Month Solo Circumnavigationsep. 2026Solar Sponsor Backed Out Before Sailing Around the World !sep. 2026Our boat won’t look the same after this | Step 495aug. 2026

Fra Sailing Uma – se kanalens båt, mannskap og alle analyserte videoer.

The Sailing Directory Newsletter

Én e-post med flåtens beste funn – øyeblikkene, båtene og historiene som er verdt din seertid. Skriv inn din egen adresse for å få din egen kopi.