Entre Terras e Mares · βίντεο

Τι καλύπτει αυτό το βίντεο

Edgar and Sâmia fabricate custom companionway hatch covers for their boat after determining that off-the-shelf components do not fit the vessel's dimensions.13:57 Because the original mold was too narrow, the crew cuts the fiberglass hatch sections in half to widen them, creating a custom extension to achieve the necessary width.2:37 They use a mixture of talc and fiberglass resin to fillet the joints and reinforce the structure, aiming to create a sliding, two-piece hatch system that allows for a larger opening.11:56 The design incorporates a rubber gasket seal between the overlapping sections to prevent water ingress, a recurring issue with their previous, self-designed hatch.10:44 While the structural reinforcement and fiberglass lamination continue, the team prepares to install a new tunnel component and finalize the motor positioning, including the installation of a constant-velocity joint.17:15 The project remains a learning process due to the lack of detailed construction plans for the vessel.14:28

Περισσότερα από το Entre Terras e Mares

90% of the STRUCTURE is READY S1.ep 183Ιουλ 2026WE FINISHED the bow cabin LAMINATE ! S1.ep182Ιουν 2026WE DID IT, WE FINISHED PART OF THE FORMICA IN THE BOW SUITE S1.ep 181Ιουν 2026This week the focus was on something elseΙουν 2026

Από Entre Terras e Mares — δείτε το σκάφος του καναλιού, το πλήρωμα και κάθε αναλυμένο βίντεο.

The Sailing Directory Newsletter

Ένα email με τις καλύτερες ανακαλύψεις του στόλου — τις στιγμές, τα σκάφη και τις ιστορίες που αξίζουν τον χρόνο παρακολούθησής σας. Εισάγετε τη διεύθυνσή σας για να λάβετε το δικό σας αντίγραφο.