Entre Terras e Mares · video

Hva denne videoen dekker

Edgar and Sâmia fabricate custom companionway hatch covers for their boat after determining that off-the-shelf components do not fit the vessel's dimensions.13:57 Because the original mold was too narrow, the crew cuts the fiberglass hatch sections in half to widen them, creating a custom extension to achieve the necessary width.2:37 They use a mixture of talc and fiberglass resin to fillet the joints and reinforce the structure, aiming to create a sliding, two-piece hatch system that allows for a larger opening.11:56 The design incorporates a rubber gasket seal between the overlapping sections to prevent water ingress, a recurring issue with their previous, self-designed hatch.10:44 While the structural reinforcement and fiberglass lamination continue, the team prepares to install a new tunnel component and finalize the motor positioning, including the installation of a constant-velocity joint.17:15 The project remains a learning process due to the lack of detailed construction plans for the vessel.14:28

Mer fra Entre Terras e Mares

90% of the STRUCTURE is READY S1.ep 183juli 2026WE FINISHED the bow cabin LAMINATE ! S1.ep182juni 2026WE DID IT, WE FINISHED PART OF THE FORMICA IN THE BOW SUITE S1.ep 181juni 2026This week the focus was on something elsejuni 2026

Fra Entre Terras e Mares – se kanalens båt, mannskap og alle analyserte videoer.

The Sailing Directory Newsletter

Én e-post med flåtens beste funn – øyeblikkene, båtene og historiene som er verdt din seertid. Skriv inn din egen adresse for å få din egen kopi.