Pacific Yacht Systems · βίντεο

Τι καλύπτει αυτό το βίντεο

A Starlink Mini replaces a cell booster antenna on a boat, with Pacific Yacht Systems technician Scott walking through each installation step.Watch The existing VHF antenna mount is reused with a threaded adapter sized for the Starlink Mini, tilted slightly to shed rainwater.2:58 Positioning matters: mounting too close to a radar dome causes two problems — radar interference stops Gen 2 Starlink units from functioning entirely, and a large object beside the dome creates a blind spot on that side.1:43 Because the boat already had a spare cable gland, only one new hole was needed through the hull.2:58 The factory Starlink Mini cable is retained by boosting supply voltage to 30 volts using a Victron Orion 12-to-24V DC-to-DC converter; running the unit at 12 volts is unreliable unless cable runs are very short and voltage stays above 13–14 V. A toggle switch on the Orion's remote port lets the crew cut power to the Starlink when not in use.4:28 Cable routing through ceiling panels and conduit is identified as the most labor-intensive part of a marine Starlink installation compared with a home setup.5:36

Περισσότερα από το Pacific Yacht Systems

There Is NO MORE ROOM For Additional Batteries, What Do You Do? PYS Tech TalkΣεπ 2026DIY vs Professional Boat Electronics, What to Look for When Buying Used - PYS Tech TalkΑυγ 2026When Battery Charging Through An Inverter Might Make Sense - PYS Tech TalkΑυγ 2026Upgrading Your Alternator? These Are OUR Top Tips - PYS Tech TalkΑυγ 2026

Από Pacific Yacht Systems — δείτε το σκάφος του καναλιού, το πλήρωμα και κάθε αναλυμένο βίντεο.

The Sailing Directory Newsletter

Ένα email με τις καλύτερες ανακαλύψεις του στόλου — τις στιγμές, τα σκάφη και τις ιστορίες που αξίζουν τον χρόνο παρακολούθησής σας. Εισάγετε τη διεύθυνσή σας για να λάβετε το δικό σας αντίγραφο.