Starlink Installation Guide: Marine Internet Setup for Boats
June 13, 2026 · 6 min · 5K views
Crew member installs cable gland on boat deck
What this video covers
A Starlink Mini replaces a cell booster antenna on a boat, with Pacific Yacht Systems technician Scott walking through each installation step.▶ 0:00 The existing VHF antenna mount is reused with a threaded adapter sized for the Starlink Mini, tilted slightly to shed rainwater.▶ 2:58 Positioning matters: mounting too close to a radar dome causes two problems — radar interference stops Gen 2 Starlink units from functioning entirely, and a large object beside the dome creates a blind spot on that side.▶ 1:43 Because the boat already had a spare cable gland, only one new hole was needed through the hull.▶ 2:58 The factory Starlink Mini cable is retained by boosting supply voltage to 30 volts using a Victron Orion 12-to-24V DC-to-DC converter; running the unit at 12 volts is unreliable unless cable runs are very short and voltage stays above 13–14 V. A toggle switch on the Orion's remote port lets the crew cut power to the Starlink when not in use.▶ 4:28 Cable routing through ceiling panels and conduit is identified as the most labor-intensive part of a marine Starlink installation compared with a home setup.▶ 5:36
More from Pacific Yacht Systems
From Pacific Yacht Systems — see the channel’s boat, crew, and every analyzed video.