BoatworksToday · βίντεο

Τι καλύπτει αυτό το βίντεο

To prepare for a two-day fiberglass training seminar at the Annapolis Boat Show, Andy of BoatworksToday fabricates 24 individual 12-by-16-inch fiberglass practice panels.1:54 He constructs a large 4-by-8-foot mold surface using a melamine-faced board over OSB, sealing the edges with tape to prevent resin bonding.2:30 To ensure clean release, he applies a base layer of waxed gel coat followed by a coat of polyvinyl alcohol (PVA).3:26 He uses 1808 biaxial fiberglass with a chop-strand backer and laminating polyester resin, applying three layers to achieve a final thickness of approximately 3 to 4 millimeters.8:08 The laminating resin allows for extended work time between layers, enabling him to pause production overnight without additional surface preparation.8:52 Once cured, the large sheet is cut into the final 24 panels, which are crated for shipment to Maryland.17:16 Using a multi-layered release system of wax and PVA ensures that fiberglass laminates separate cleanly from absorbent mold surfaces.

Περισσότερα από το BoatworksToday

New Epoch Batteries Just Landed for My Victron System But It's On Hold For Annapolis Boat Show Prep!Σεπ 2026I Was Wrong About My Boat's Victron Wiring (You Were Right!)Σεπ 2026Will This Entire Victron Electrical System Fit In My Little Boat?Αυγ 2026The Primer Mistake You're Probably Making Painting Your Boat: Film Thickness, Not Smoothness!Αυγ 2026

Από BoatworksToday — δείτε το σκάφος του καναλιού, το πλήρωμα και κάθε αναλυμένο βίντεο.

The Sailing Directory Newsletter

Ένα email με τις καλύτερες ανακαλύψεις του στόλου — τις στιγμές, τα σκάφη και τις ιστορίες που αξίζουν τον χρόνο παρακολούθησής σας. Εισάγετε τη διεύθυνσή σας για να λάβετε το δικό σας αντίγραφο.