BoatworksToday · video

Cosa tratta questo video

To prepare for a two-day fiberglass training seminar at the Annapolis Boat Show, Andy of BoatworksToday fabricates 24 individual 12-by-16-inch fiberglass practice panels.1:54 He constructs a large 4-by-8-foot mold surface using a melamine-faced board over OSB, sealing the edges with tape to prevent resin bonding.2:30 To ensure clean release, he applies a base layer of waxed gel coat followed by a coat of polyvinyl alcohol (PVA).3:26 He uses 1808 biaxial fiberglass with a chop-strand backer and laminating polyester resin, applying three layers to achieve a final thickness of approximately 3 to 4 millimeters.8:08 The laminating resin allows for extended work time between layers, enabling him to pause production overnight without additional surface preparation.8:52 Once cured, the large sheet is cut into the final 24 panels, which are crated for shipment to Maryland.17:16 Using a multi-layered release system of wax and PVA ensures that fiberglass laminates separate cleanly from absorbent mold surfaces.

Altro da BoatworksToday

I Was Wrong About My Boat's Victron Wiring (You Were Right!)set 2026Will This Entire Victron Electrical System Fit In My Little Boat?ago 2026The Primer Mistake You're Probably Making Painting Your Boat: Film Thickness, Not Smoothness!ago 2026V-Berth Electrical Layout On A Small Sailboat: It's Tight, But It Should Work!ago 2026

Da BoatworksToday — guarda la barca, l'equipaggio e ogni video analizzato del canale.

The Sailing Directory Newsletter

Una email con le migliori scoperte della flotta — i momenti, le barche e le storie che meritano il tuo tempo di visione. Inserisci il tuo indirizzo per riceverne una copia.