Sven Yrvind · βίντεο

Τι καλύπτει αυτό το βίντεο

Sven Yrvind demonstrates why carbon fiber laminated to the inside face of plywood produces far greater impact resistance than carbon applied to the outside. Striking a 9mm plywood panel reinforced on the outside with a hammer drives the carbon fiber straight through, causing catastrophic failure visible on the reverse face.▶ 1:11 Striking the same panel from the outside when carbon is on the inside produces only a small dent; the inner carbon layer spreads the impact forces outward at 45 degrees across a wide area, preventing penetration.▶ 2:01 The mechanism is force distribution over area and time: outside carbon concentrates the load at the point of impact and fractures immediately, while inside carbon intercepts the spreading stress cone and carries it across a much larger surface.▶ 2:29 Yrvind notes the fiber is polyester fiber, not glass fiber, and distinguishes this from carbon. The practical rule for amateur builders reinforcing plywood hulls: bond carbon fiber to the interior face, not the exterior.▶ 2:58

Περισσότερα από το Sven Yrvind

Kai the bow paddle.Ιουλ 2026About safety.Ιουλ 2026My solution to crossing the Doldrums without using an engine.Ιουλ 2026Goose Barnacles Remower.Ιουλ 2026

Από Sven Yrvind — δείτε το σκάφος του καναλιού, το πλήρωμα και κάθε αναλυμένο βίντεο.