Living For Sail · βίντεο

Τι καλύπτει αυτό το βίντεο

Restoring discontinued ProFurl LC42 and N42 headsail furlers requires replacing internal bearings, seals, and snap rings with off-the-shelf components. Because the aluminum extrusions and castings are no longer manufactured, the rebuild focuses on the lower drum units and upper swivels. To disassemble, use a small pick to expose the seal, then drill two holes in the cover to extract it with screws and a slide hammer. Heating the aluminum housing in an oven to 250°F allows the bearings to be pressed out or tapped through without damaging the casing. Use carbon steel bearings rather than stainless, as stainless steel deforms under the high loads of a furling system. After cleaning, fill scratches in the aluminum with JB Weld and smooth with a file. During reassembly, use PVC pipe sections as custom bearing drivers to ensure even pressure and prevent side-loading. Lubricate with Tef-Gel to isolate metals and protect against water intrusion.

Σκάφη σε αυτό το βίντεο

Περισσότερα από το Living For Sail

Can I Save This Bronze Cleat? Sailboat Bulwark RebuildΣεπ 2026This Was Inside The Boat!? — Should I Put It Back?Σεπ 2026BACK to Work on ANTIDOTE! - How I Used 3D Printing to Fix My BoatΑυγ 2026⛵️ I Tried Boiling Water Out of My Boat... It Actually Worked - sort of?!Ιουλ 2026

Από Living For Sail — δείτε το σκάφος του καναλιού, το πλήρωμα και κάθε αναλυμένο βίντεο.

The Sailing Directory Newsletter

Ένα email με τις καλύτερες ανακαλύψεις του στόλου — τις στιγμές, τα σκάφη και τις ιστορίες που αξίζουν τον χρόνο παρακολούθησής σας. Εισάγετε τη διεύθυνσή σας για να λάβετε το δικό σας αντίγραφο.