Living For Sail · vidéo

Ce que couvre cette vidéo

Restoring discontinued ProFurl LC42 and N42 headsail furlers requires replacing internal bearings, seals, and snap rings with off-the-shelf components. Because the aluminum extrusions and castings are no longer manufactured, the rebuild focuses on the lower drum units and upper swivels. To disassemble, use a small pick to expose the seal, then drill two holes in the cover to extract it with screws and a slide hammer. Heating the aluminum housing in an oven to 250°F allows the bearings to be pressed out or tapped through without damaging the casing. Use carbon steel bearings rather than stainless, as stainless steel deforms under the high loads of a furling system. After cleaning, fill scratches in the aluminum with JB Weld and smooth with a file. During reassembly, use PVC pipe sections as custom bearing drivers to ensure even pressure and prevent side-loading. Lubricate with Tef-Gel to isolate metals and protect against water intrusion.

Bateaux dans cette vidéo

Plus de vidéos de Living For Sail

Can I Save This Bronze Cleat? Sailboat Bulwark Rebuildsept. 2026This Was Inside The Boat!? — Should I Put It Back?sept. 2026BACK to Work on ANTIDOTE! - How I Used 3D Printing to Fix My Boataoût 2026⛵️ I Tried Boiling Water Out of My Boat... It Actually Worked - sort of?!juil. 2026

De Living For Sail — voir le bateau, l'équipage et chaque vidéo analysée de la chaîne.

The Sailing Directory Newsletter

Un e-mail avec les meilleures trouvailles de la flotte — les moments, les bateaux et les histoires qui valent la peine d'être regardés. Entrez votre adresse pour recevoir votre propre exemplaire.