BoatworksToday · video

¿Qué cubre este video?

Crazing in the cockpit coaming of a 1983 J29 often results from a resin-starved initial layup during the boat's original construction, where the gel coat lacks a stable substrate and the underlying chop strand matting prints through.5:01 To permanently repair this cracking before painting, sand the affected area down to the bare fiberglass to remove the brittle gel coat and the dry, unsaturated glass layer.9:01 Apply one or two layers of 1.5-ounce chop strand matting using laminating polyester resin in temperatures above 60–65 degrees Fahrenheit.9:38 Follow this with a layer of waxed gel coat to seal the fiberglass and provide a high-viscosity sanding buffer that creates a smooth surface without requiring excessive material removal.9:57 Once the surface is stable, use an epoxy-based fairing compound like TotalBoat TotalFair to minimize shrinkage before priming and painting.12:57 Two-part catalyzed paints offer superior chemical resistance and hardness compared to one-part paints, though they cost significantly more.14:33 Stabilizing the substrate with new fiberglass prevents the original crazing pattern from telegraphing through the final paint finish.

Barcos en este video

Más de BoatworksToday

New Epoch Batteries Just Landed for My Victron System But It's On Hold For Annapolis Boat Show Prep!sep 2026I Was Wrong About My Boat's Victron Wiring (You Were Right!)sep 2026Will This Entire Victron Electrical System Fit In My Little Boat?ago 2026The Primer Mistake You're Probably Making Painting Your Boat: Film Thickness, Not Smoothness!ago 2026

De BoatworksToday — ve el barco, la tripulación y cada video analizado del canal.

The Sailing Directory Newsletter

Un correo electrónico con los mejores hallazgos de la flota: los momentos, barcos e historias que valen tu tiempo de visualización. Ingresa tu propia dirección para obtener tu propia copia.