BoatworksToday · video

Cosa tratta questo video

Crazing in the cockpit coaming of a 1983 J29 often results from a resin-starved initial layup during the boat's original construction, where the gel coat lacks a stable substrate and the underlying chop strand matting prints through.5:01 To permanently repair this cracking before painting, sand the affected area down to the bare fiberglass to remove the brittle gel coat and the dry, unsaturated glass layer.9:01 Apply one or two layers of 1.5-ounce chop strand matting using laminating polyester resin in temperatures above 60–65 degrees Fahrenheit.9:38 Follow this with a layer of waxed gel coat to seal the fiberglass and provide a high-viscosity sanding buffer that creates a smooth surface without requiring excessive material removal.9:57 Once the surface is stable, use an epoxy-based fairing compound like TotalBoat TotalFair to minimize shrinkage before priming and painting.12:57 Two-part catalyzed paints offer superior chemical resistance and hardness compared to one-part paints, though they cost significantly more.14:33 Stabilizing the substrate with new fiberglass prevents the original crazing pattern from telegraphing through the final paint finish.

Barche in questo video

Altro da BoatworksToday

New Epoch Batteries Just Landed for My Victron System But It's On Hold For Annapolis Boat Show Prep!set 2026I Was Wrong About My Boat's Victron Wiring (You Were Right!)set 2026Will This Entire Victron Electrical System Fit In My Little Boat?ago 2026The Primer Mistake You're Probably Making Painting Your Boat: Film Thickness, Not Smoothness!ago 2026

Da BoatworksToday — guarda la barca, l'equipaggio e ogni video analizzato del canale.

The Sailing Directory Newsletter

Una email con le migliori scoperte della flotta — i momenti, le barche e le storie che meritano il tuo tempo di visione. Inserisci il tuo indirizzo per riceverne una copia.