Living For Sail · video

Cosa tratta questo video

John restores a Yanmar 3GM marine diesel engine, focusing on correcting piston-to-head clearance and verifying fuel injection timing before final assembly and painting.▶ 0:09 After measuring an initial clearance of 46 thousandths of an inch—exceeding the 27-to-35 thousandths specification—he replaces the aftermarket head gasket with an official Yanmar OE gasket.▶ 0:46 This adjustment brings the clearance to 33 thousandths of an inch.▶ 10:31 He verifies fuel injection timing by using a manual procedure to observe fuel movement at the pump while rotating the crankshaft, confirming the original shims provide correct timing.▶ 5:34 For the exterior, he applies an AkzoNobel epoxy primer followed by a high-gloss Allcraft 3000 polyurethane top coat to protect against fuel and oil.▶ 11:18 During the initial start-up, he uses a mechanical gauge to confirm oil pressure after the stock Yanmar low-pressure switch fails.▶ 21:06 The engine runs successfully, though it produces minor white smoke as the new rings seat.▶ 23:12

Barche in questo video

Altro da Living For Sail

⛵️ This DIY Sailboat Repair Has To Work... Right?giu 2026Uh oh... 2 Reasons why there is No New Video Today...mag 2026⛵️ Can a 3D Printed Bracket Actually HOLD UP?mag 2026⛵️ From Simple Fix to Full Transom Rebuild - A DIY Project Boatapr 2026

Da Living For Sail — guarda la barca, l'equipaggio e ogni video analizzato del canale.