BoatworksToday · video

Cosa tratta questo video

Andy permanently closes four portlight openings on a 1970 Paceship Yachts Westwind 24 by glassing them over with fiberglass backed by laminating polyester resin.0:32 The hull laminate at the openings measures under a quarter inch (roughly 5 mm), so Andy grinds a full-thickness taper — approximately two inches wide around each opening — to create a feathered edge for the new glass to bond to.5:08 He chooses non-waxed laminating polyester resin over epoxy specifically because polyester allows successive layers to be added the next day without sanding between sessions; epoxy would require sanding every inter-session bond line.2:40 The backer pieces are wet out on vacuum-bagging plastic (impervious to styrene) rather than standard 6-mil poly sheeting, which styrene would melt.1:51 Andy uses a discontinued Festool RAS 115 angle grinder running at 1,500 RPM — far slower than a standard grinder — for controlled taper grinding with roughly 75–80% dust capture.6:49 Backer pieces are aligned with tape, bonded with structural putty, and set with non-waxed resin so the next session can proceed directly to laminating without additional prep.12:18 The practical takeaway: matching resin type to the work schedule — polyester for multi-session layups, epoxy when a single uninterrupted session is feasible — eliminates unnecessary sanding.

Altro da BoatworksToday

Why Is My 920Ah Sailboat Battery Bank So Big FOR THIS TINY SAILBOAT?? This Is Why ;-)!ott 2026New Epoch Batteries Just Landed for My Victron System But It's On Hold For Annapolis Boat Show Prep!set 2026I Was Wrong About My Boat's Victron Wiring (You Were Right!)set 2026Will This Entire Victron Electrical System Fit In My Little Boat?ago 2026

Da BoatworksToday — guarda la barca, l'equipaggio e ogni video analizzato del canale.

The Sailing Directory Newsletter

Una email con le migliori scoperte della flotta — i momenti, le barche e le storie che meritano il tuo tempo di visione. Inserisci il tuo indirizzo per riceverne una copia.