Sailing SV Delos · video

Hva denne videoen dekker

The crew building the aluminum catamaran SV Delos 2.0 uses an English wheel to shape flat hull plates into the complex curves required for the vessel's bottom and skeg sections.1:47 The process involves feeding aluminum sheets between a top roller and a bottom V-roller to stretch the material, guided by reference lines and templates provided in the build kit.2:04 Because the plates do not always sit flush against the frame, the team uses chain blocks to pull them into position before tack welding.15:58 To prevent heat-induced distortion when welding the thick skeg plates, two people weld simultaneously on opposite sides to balance the thermal load.17:04 The stern tube, which houses the cutlass bearing and propeller shaft, is installed at a 12-degree angle relative to the waterline.16:43 The team notes that metal construction allows for easier structural adjustments compared to fiberglass.16:16 Proper tensioning on the English wheel is critical, as excessive pressure can over-curve the metal and ruin the plate.3:49

Mer fra Sailing SV Delos

OUR MAST: The INCREDIBLE Process! (EXTENDED CUT) Building Our Own Aluminum Catamaran Pt. 87sep. 2026You Need to See This 🤯 Building Our Own Aluminum Catamaran Pt. 86sep. 2026Fit or FAIL 🫣 Building Our Own Aluminum Catamaran Pt. 85sep. 2026This Is Where It Gets INTERESTING…Aluminum Catamaran Build Pt. 84aug. 2026

Fra Sailing SV Delos – se kanalens båt, mannskap og alle analyserte videoer.

The Sailing Directory Newsletter

Én e-post med flåtens beste funn – øyeblikkene, båtene og historiene som er verdt din seertid. Skriv inn din egen adresse for å få din egen kopi.