Tips from a Shipwright · video

Hva denne videoen dekker

To prepare a wooden boat hull for framing, the shipwright trims excess cedar planking from the chine logs using a reciprocating saw with the blade teeth ground down at the tip to prevent damage to the log.0:45 After removing temporary screws used to stabilize the side planks against the stem, the shipwright uses a handsaw to cut the planking flush to the rabbet line.2:06 A block plane finishes the cedar surface to ensure it sits flush with the outboard side of the chine.3:51 The frames, constructed from yellow bark oak at 1 1/8-inch thickness and 2 1/2-inch width, are clamped into position with a 1/2-inch gap between the frame end and the chine log.4:37 To fair the transom corner, an electric plane with a zip-tie trigger lock removes material down to a pre-marked control line.8:02 The hull design features a flat bottom that transitions to a 4-inch rise approximately 5 feet aft of the stem.9:46

Mer fra Tips from a Shipwright

Building Orca - Ep. 23: Mold FIVEmars 2026Progressive Bevelingfeb. 20261958 Harley Davidson Panhead Motorcycle - For Salefeb. 2026Building Orca - Ep. 22: Lofting Pt. 3 - Full Scale Linesjan. 2026

Fra Tips from a Shipwright – se kanalens båt, mannskap og alle analyserte videoer.

The Sailing Directory Newsletter

Én e-post med flåtens beste funn – øyeblikkene, båtene og historiene som er verdt din seertid. Skriv inn din egen adresse for å få din egen kopi.