BoatHowTo · video

Hva denne videoen dekker

Nigel Calder explains how to detect AC and DC ground leaks on a boat in a short Q&A with host Jan Attenstedt. For AC systems connected to shore power, clamping the shore power cord with a sensitive AC clamp meter reveals any leak current finding a path back to the dock through the water — a reading in milliamps or higher indicates a fault.▶ 0:39 DC ground leaks are harder to isolate systematically; the diagnostic principle is identifying disparities between the positive and negative sides of a circuit, which signal that fault current is returning to the battery through an unintended path rather than through the boat's wiring.▶ 1:17 Calder points to the negative side of the DC system as the critical factor: a continuous, low-resistance path back to battery negative leaves no alternative route for stray current.▶ 2:33 Grounded metal objects aboard create those alternative paths, and they become a problem only when the negative wiring has weaknesses.▶ 2:20 Correct wiring from the outset is the primary prevention.▶ 0:00

Mer fra BoatHowTo

ONE SWITCH for TWO PUMPS?? (Pontoon Boat Setup) | Ask The Expert with NIGEL CALDERjuli 2026OIL LEAKS at the Crankshaft... | Ask The Expert with NIGEL CALDERjuli 20261-2-both switch - Cost effective charging system on small boats? 🤔 Ask The Expert with NIGEL CALDERjuni 202648V or 24V - What makes more sense on a Boat? | Ask The Expert with NIGEL CALDERjuni 2026

Fra BoatHowTo – se kanalens båt, mannskap og alle analyserte videoer.