BoatworksToday · video

Hva denne videoen dekker

Andy rebuilds the transom of a Bertram 25 by installing Coosa Blue Water 26 fiberglass-reinforced foam panels.2:01 After prepping the transom area, he cuts a one-inch thick panel to fit the recessed section, using a jigsaw equipped with a carbide-tipped blade to prevent premature wear from the fiberglass strands.2:50 To ensure a precise fit, he cuts the panel slightly smaller than the template.4:22 When determining the thickness for subsequent layers, he compares one-inch and half-inch panels to achieve a flush fit against the existing transom contours.8:17 He selects the half-inch material to maintain better surface contact and avoid excessive grinding, then uses a router with a carbide-tipped flush trim bit to create an exact copy of the first panel.9:53 Before final installation, he fills low spots and imperfections on the transom surface using Total Fair epoxy filler to ensure a strong bond with the new coring.13:34

Mer fra BoatworksToday

Will This Entire Victron Electrical System Fit In My Little Boat?aug. 2026The Primer Mistake You're Probably Making Painting Your Boat: Film Thickness, Not Smoothness!aug. 2026V-Berth Electrical Layout On A Small Sailboat: It's Tight, But It Should Work!aug. 2026Putting the Anona Orbis Solar Camera to Work on My Property ~ 360 Security Camerajuli 2026

Fra BoatworksToday – se kanalens båt, mannskap og alle analyserte videoer.

The Sailing Directory Newsletter

Én e-post med flåtens beste funn – øyeblikkene, båtene og historiene som er verdt din seertid. Skriv inn din egen adresse for å få din egen kopi.