Stella Overboard · video

Hva denne videoen dekker

A planned quick haul-out at Red Rock Marina in Malaysia stretched to three weeks as Camille and Jesse worked through compounding repairs on their sailboat Stella.▶ 13:03 The rudder had a crack with water ingress; they cut it out, replaced the core with Xpando foam, glassed it, applied two coats of Primacon primer, then anti-foul.▶ 1:03 Yacht Supplies Malaysia (YSM) assisted with dropping the rudder and disconnecting the steering cables.▶ 1:38 The cutlass bearing — a custom Delrin unit sourced from Perth, Western Australia — was pressed in with mega epoxy, with friends holding position underneath while the shaft was slid back through and reconnected to the gearbox with a dripless seal and coupling.▶ 4:02 A Flexi Fold propeller went back on, anodes were refitted after drilling out an undersized bolt, and Prop 1 two-coat anti-foul was applied to the propeller and shaft in 35°C heat.▶ 8:49 The hull received two coats of primer and five coats of Micron 99 anti-foul.▶ 12:03 After splashdown, the drip seal and through-hulls showed no leaks, and engine speed at 1,800 rpm jumped from roughly 4.5 knots to nearly 6 knots.▶ 15:10 Fresh anti-foul and a correctly fitted cutlass bearing together recovered nearly two knots of boat speed under engine.▶ 15:16

Mer fra Stella Overboard

2 Girls, One Sailboat & Our Biggest Milestone Yetjuli 2026A Girl Asked to Join Our Sailboat... So We Said Yesjuli 2026Sailing to Paradise for Perfect Wavesjuni 2026The Most Remote Wave We've Found Yetjuni 2026

Fra Stella Overboard – se kanalens båt, mannskap og alle analyserte videoer.