BoatworksToday · video

Hva denne videoen dekker

To determine if an existing hull finish is a one-part or two-part paint, perform a solvent test by taping a solvent-soaked rag or cotton ball to an obscure area of the hull for 30 minutes. If the paint wrinkles, bubbles, or melts, the surface is a one-part paint and is incompatible with two-part topcoats, which will cause the finish to lift and wrinkle during application. If the surface remains intact, it is a two-part paint and can be overcoated after proper scuffing and priming. For Awlgrip systems, use T-006 epoxy reducer for the test, as it is a more aggressive solvent that ensures compatibility. Additionally, perform an adhesion test by cutting a cross-hatch grid into the paint with a razor and applying strong tape, such as shrink-wrap tape, then pulling it off quickly to check for lifting. A successful solvent test confirms the existing finish can be overcoated without stripping the hull to bare fiberglass.

Mer fra BoatworksToday

I Was Wrong About My Boat's Victron Wiring (You Were Right!)sep. 2026Will This Entire Victron Electrical System Fit In My Little Boat?aug. 2026The Primer Mistake You're Probably Making Painting Your Boat: Film Thickness, Not Smoothness!aug. 2026V-Berth Electrical Layout On A Small Sailboat: It's Tight, But It Should Work!aug. 2026

Fra BoatworksToday – se kanalens båt, mannskap og alle analyserte videoer.

The Sailing Directory Newsletter

Én e-post med flåtens beste funn – øyeblikkene, båtene og historiene som er verdt din seertid. Skriv inn din egen adresse for å få din egen kopi.