RAN Sailing · video

Hva denne videoen dekker

Johan and Malin construct two custom cradle boxes to support their 50-foot boat hull during an upcoming rollover operation.1:28 The front box spans 2.3 meters, while the aft box spans 4.3 meters to accommodate the hull's width.5:27 Johan builds the boxes using plywood, epoxy, screws, and wooden dowels, incorporating internal grids to manage compression loads.2:16 To address future bending forces when the boxes act as a cart for moving the hull, he reinforces the structures with 8-millimeter-thick steel plates and plans for additional steel bracing later.9:35 The aft box weighs approximately 120 kilograms, requiring the couple to install a ceiling-mounted tackle system to hoist it into position against the hull.13:20 They line the contact surfaces with soft mats to distribute pressure and protect the hull's finish.12:07 The boxes are positioned to leave the propeller shaft and rudder areas accessible for future work.18:25

Mer fra RAN Sailing

Will the Sanding EVER End? Building Our Dreamboat - Ep. 503 Ran Sailingsep. 2026Something's Not Right Here! Building Our 52ft Sailboat - Ep. 502sep. 2026This Is Where Boat Builds Break People - Ep. 501 Ran Sailingaug. 2026Our 52ft Sailboat Build Reaches Another Milestone! - Ep. 500 Ran Sailingaug. 2026

Fra RAN Sailing – se kanalens båt, mannskap og alle analyserte videoer.

The Sailing Directory Newsletter

Én e-post med flåtens beste funn – øyeblikkene, båtene og historiene som er verdt din seertid. Skriv inn din egen adresse for å få din egen kopi.