Sailing Artha · vídeo

O que este vídeo aborda

Nicole replaces the raw water pump on Artha's Yanmar 3GM30F engine after a persistent shaft seal leak caused by a groove worn into the pump shaft.▶ 0:10 The old pump, sourced from Beaton's, had been running with an improvised fix — a mismatched gasket and a screw — and was visibly deteriorated.▶ 1:19 During removal, Nicole discovers the drive belt is broken, a failure that could have caused overheating.▶ 1:50 She replaces the broken belt by loosening the alternator, then installs the new pump.▶ 2:07 She opts not to replace the second belt, noting a planned serpentine pulley conversion kit makes it unnecessary.▶ 2:54 The new pump is seated and tightened.▶ 3:34 Nicole also identifies the kill cable as the next repair: the current setup requires manually pushing a lever every time the engine starts.▶ 5:03 A broken drive belt found only during pump removal underscores the value of inspecting adjacent components during any raw water pump replacement.

Barcos neste vídeo

Mais de Sailing Artha

S3E44 Artha plays in the wind again12/2025

De Sailing Artha — veja o barco, a tripulação e todos os vídeos analisados do canal.