BoatHowTo · vídeo

O que este vídeo aborda

Crankshaft oil seal leaks on older cruising engines — specifically the Perkins 4107 and Perkins 4108 and engines using the same block under different labels — are the focus of this exchange between Jan Attenstedt and Nigel Calder.▶ 0:25 Calder explains that both the front and rear crankshaft seals on these engines are prone to leaking over time, while most modern engines rarely develop the same problem.▶ 0:42 Replacing either seal requires significant disassembly: the rear seal demands pulling the transmission, and the front seal requires removing the crankshaft pulley, with further teardown depending on how the housing is configured.▶ 1:03 Because the procedure varies too much between engine types to give a generic answer, Calder's firm recommendation is to obtain the workshop manual for the specific engine before attempting the job.▶ 1:16 No step-by-step repair sequence is demonstrated; the exchange is diagnostic and advisory.

Mais de BoatHowTo

ONE SWITCH for TWO PUMPS?? (Pontoon Boat Setup) | Ask The Expert with NIGEL CALDER07/20261-2-both switch - Cost effective charging system on small boats? 🤔 Ask The Expert with NIGEL CALDER06/202648V or 24V - What makes more sense on a Boat? | Ask The Expert with NIGEL CALDER06/2026How to identify GROUND LEAKS on your BOAT! | Ask The Expert with NIGEL CALDER06/2026

De BoatHowTo — veja o barco, a tripulação e todos os vídeos analisados do canal.