Project Brupeg · βίντεο

Τι καλύπτει αυτό το βίντεο

Fabricating custom steel mounts for a generator installation requires precise alignment and structural reinforcement to ensure the unit remains secure under load. The project involves replacing original crossmembers with 100mm by 16mm flat bar, which is drilled and tapped to accept the generator's rubber engine mounts.9:43 When drilling and tapping steel, using the correct drill bit size is critical; attempting to force a tap into an undersized hole results in damaged threads and requires re-drilling.12:04 To strengthen the mounts, 10mm-thick gussets are welded into the corners of the steel assembly.19:52 TIG welding is preferred in the engine room to minimize splatter, though high heat can cause tungsten electrodes to bend if not managed properly.29:46 When forced to relocate to a "no-work" berth on short notice, the crew must prioritize bolting down the generator and sealing the deck opening to maintain the project timeline.21:17 Proper preparation, including the use of drilling templates and radius-grinding sharp edges, prevents structural failure and injury.3:52

Περισσότερα από το Project Brupeg

What caused the steering to fail - Project Brupeg Ep.463Οκτ 2026CHAOS! & our first Night Time Trailer Haul Out - Project Brupeg Ep.462Σεπ 2026Look, It's possible we should have cleaned this before now... Project Brupeg Ep.461Σεπ 2026The Ridiculously Powerful Davit Winch - Project Brupeg Ep.460Σεπ 2026

Από Project Brupeg — δείτε το σκάφος του καναλιού, το πλήρωμα και κάθε αναλυμένο βίντεο.

The Sailing Directory Newsletter

Ένα email με τις καλύτερες ανακαλύψεις του στόλου — τις στιγμές, τα σκάφη και τις ιστορίες που αξίζουν τον χρόνο παρακολούθησής σας. Εισάγετε τη διεύθυνσή σας για να λάβετε το δικό σας αντίγραφο.