Project Brupegvideo
Genset Mounts & when plans turn to S#-*T! - Project Brupeg Ep. 355
May 12, 2024 · 39 min · 29K views
What this video covers
Fabricating custom steel mounts for a generator installation requires precise alignment and structural reinforcement to ensure the unit remains secure under load. The project involves replacing original crossmembers with 100mm by 16mm flat bar, which is drilled and tapped to accept the generator's rubber engine mounts.9:43 When drilling and tapping steel, using the correct drill bit size is critical; attempting to force a tap into an undersized hole results in damaged threads and requires re-drilling.12:04 To strengthen the mounts, 10mm-thick gussets are welded into the corners of the steel assembly.19:52 TIG welding is preferred in the engine room to minimize splatter, though high heat can cause tungsten electrodes to bend if not managed properly.29:46 When forced to relocate to a "no-work" berth on short notice, the crew must prioritize bolting down the generator and sealing the deck opening to maintain the project timeline.21:17 Proper preparation, including the use of drilling templates and radius-grinding sharp edges, prevents structural failure and injury.3:52
More from Project Brupeg
From Project Brupeg — see the channel’s boat, crew, and every analyzed video.
The Sailing Directory Newsletter
One email with the fleet's best finds — the moments, boats, and stories worth your watch time. Enter your own address to get your own copy.