BoatworksToday · βίντεο

Τι καλύπτει αυτό το βίντεο

Andy completes the heavy fiberglass grinding phase of a boat interior restoration, transitioning from structural demolition to rebuilding.8:18 To prepare the hull for new bulkheads and flooring, he removes residual fiberglass dust by power washing the interior, having first drilled drainage holes in the hull to prevent water accumulation.10:12 He addresses surface defects on Kusa panels using Total Boat structural repair putty, applying it wet-on-wet with polyester resin and 1708 fiberglass cloth.2:35 To restore crusty, resin-caked fin rollers, he burns off the cured resin with a torch, then cleans the remaining residue with acetone and a wire brush.3:22 Future project steps include glassing over the temporary drainage holes, leveling the keel, and installing bulkheads that support the rigging stays.14:24 Once the bulkheads are set, the layout for the V-berth electronics, including Victron components and EPIC lithium-ion batteries, will follow.14:52

Περισσότερα από το BoatworksToday

Why Is My 920Ah Sailboat Battery Bank So Big FOR THIS TINY SAILBOAT?? This Is Why ;-)!Οκτ 2026New Epoch Batteries Just Landed for My Victron System But It's On Hold For Annapolis Boat Show Prep!Σεπ 2026I Was Wrong About My Boat's Victron Wiring (You Were Right!)Σεπ 2026Will This Entire Victron Electrical System Fit In My Little Boat?Αυγ 2026

Από BoatworksToday — δείτε το σκάφος του καναλιού, το πλήρωμα και κάθε αναλυμένο βίντεο.

The Sailing Directory Newsletter

Ένα email με τις καλύτερες ανακαλύψεις του στόλου — τις στιγμές, τα σκάφη και τις ιστορίες που αξίζουν τον χρόνο παρακολούθησής σας. Εισάγετε τη διεύθυνσή σας για να λάβετε το δικό σας αντίγραφο.