BoatworksToday · βίντεο

Τι καλύπτει αυτό το βίντεο

Removing old bottom paint and improper topside paint from a transom requires 40-grit sandpaper to reach bare fiberglass or original gel coat, as finer grits clog quickly.3:59 Uneven surfaces and voids, identified by a higher-pitched sound when tapped, indicate poor previous repairs that require grinding down to solid material.7:40 To fill a quarter-inch deep void, six layers of 1708 biaxial fiberglass cloth and epoxy are necessary, though five layers followed by fairing compound often provide a smoother finish.9:16 When fitting stiff 1708 cloth into tight stringer extensions, sanding the thickness of the fiberglass can increase flexibility.13:23 Total Fair compound serves as an initial fairing agent to level the surface for a watertight seal.6:04 Pencil marks are preferred over permanent markers for layout, as marker ink can bleed through subsequent primer and paint layers.6:40

Περισσότερα από το BoatworksToday

Why Is My 920Ah Sailboat Battery Bank So Big FOR THIS TINY SAILBOAT?? This Is Why ;-)!Οκτ 2026New Epoch Batteries Just Landed for My Victron System But It's On Hold For Annapolis Boat Show Prep!Σεπ 2026I Was Wrong About My Boat's Victron Wiring (You Were Right!)Σεπ 2026Will This Entire Victron Electrical System Fit In My Little Boat?Αυγ 2026

Από BoatworksToday — δείτε το σκάφος του καναλιού, το πλήρωμα και κάθε αναλυμένο βίντεο.

The Sailing Directory Newsletter

Ένα email με τις καλύτερες ανακαλύψεις του στόλου — τις στιγμές, τα σκάφη και τις ιστορίες που αξίζουν τον χρόνο παρακολούθησής σας. Εισάγετε τη διεύθυνσή σας για να λάβετε το δικό σας αντίγραφο.