BoatworksToday · video

Hva denne videoen dekker

Removing old bottom paint and improper topside paint from a transom requires 40-grit sandpaper to reach bare fiberglass or original gel coat, as finer grits clog quickly.3:59 Uneven surfaces and voids, identified by a higher-pitched sound when tapped, indicate poor previous repairs that require grinding down to solid material.7:40 To fill a quarter-inch deep void, six layers of 1708 biaxial fiberglass cloth and epoxy are necessary, though five layers followed by fairing compound often provide a smoother finish.9:16 When fitting stiff 1708 cloth into tight stringer extensions, sanding the thickness of the fiberglass can increase flexibility.13:23 Total Fair compound serves as an initial fairing agent to level the surface for a watertight seal.6:04 Pencil marks are preferred over permanent markers for layout, as marker ink can bleed through subsequent primer and paint layers.6:40

Mer fra BoatworksToday

Why Is My 920Ah Sailboat Battery Bank So Big FOR THIS TINY SAILBOAT?? This Is Why ;-)!okt. 2026New Epoch Batteries Just Landed for My Victron System But It's On Hold For Annapolis Boat Show Prep!sep. 2026I Was Wrong About My Boat's Victron Wiring (You Were Right!)sep. 2026Will This Entire Victron Electrical System Fit In My Little Boat?aug. 2026

Fra BoatworksToday – se kanalens båt, mannskap og alle analyserte videoer.

The Sailing Directory Newsletter

Én e-post med flåtens beste funn – øyeblikkene, båtene og historiene som er verdt din seertid. Skriv inn din egen adresse for å få din egen kopi.