BoatworksToday · vídeo

Qué cubre este vídeo

Repairing "halos"—circular stress cracks or depressions around old hull patches—requires removing the existing plug and bridging the area with structural fiberglass to prevent future print-through.0:30 These defects typically occur because previous repairs failed to fully fill the hole or lacked a fiberglass skin to tie the plug into the surrounding laminate.3:32 To fix these, grind the area down to bare fiberglass, ensuring the depression is deep enough to accommodate both new glass and a final layer of fairing compound.17:21 Use 1708 biaxial fiberglass with epoxy, as the stitched construction of 1708 allows for proper bonding without the styrene-based binders found in standard chopped strand mat.8:19 After wetting out the glass on a non-porous surface, apply it to the repair area and consolidate with a fin roller.7:02 Once cured, apply a fairing compound like Total Boat TotalFair, sanding flush with 120-grit paper.14:17 Proper structural bridging with fiberglass prevents the plug from shifting and eliminates the halo effect.9:46

Más de BoatworksToday

New Epoch Batteries Just Landed for My Victron System But It's On Hold For Annapolis Boat Show Prep!sept 2026I Was Wrong About My Boat's Victron Wiring (You Were Right!)sept 2026Will This Entire Victron Electrical System Fit In My Little Boat?ago 2026The Primer Mistake You're Probably Making Painting Your Boat: Film Thickness, Not Smoothness!ago 2026

De BoatworksToday — mira el barco del canal, la tripulación y cada vídeo analizado.

The Sailing Directory Newsletter

Un correo electrónico con los mejores hallazgos de la flota: los momentos, barcos e historias que merecen tu tiempo de visionado. Introduce tu dirección para recibir tu propia copia.