BoatHowTo · vídeo

Qué cubre este vídeo

A 1983 Harris with mixed 12V, 24V, and 32V electrical systems — where the two engines each run on a 32V bank and one 32V bank doubles as the house battery — prompts the question of whether a single 48V lithium-ion battery in each engine room could replace the whole arrangement.▶ 0:38 Nigel Calder explains that the 32V standard is rare on boats and likely derived from a railway industry specification.▶ 1:03 Dropping a 48V system in without a full rewire is not viable: DC-to-DC converters would be needed to step down to both 24V and 32V, and a programmable converter to 32V is difficult to source.▶ 1:10 More critically, no DC-to-DC converter is large enough to supply the cranking current needed to start an engine, so a dedicated 32V cranking bank must remain regardless.▶ 1:46 Using lithium-ion for engine starting requires a battery specifically rated and designed for cranking — and it would still be the wrong voltage.▶ 2:25 The practical choice is either a substantial rewire to bring the boat to a single modern voltage standard or retaining the existing multi-voltage setup and adding 48V on top, which only introduces a fourth voltage rather than simplifying anything.▶ 2:02

Más de BoatHowTo

ONE SWITCH for TWO PUMPS?? (Pontoon Boat Setup) | Ask The Expert with NIGEL CALDERjul 2026OIL LEAKS at the Crankshaft... | Ask The Expert with NIGEL CALDERjul 20261-2-both switch - Cost effective charging system on small boats? 🤔 Ask The Expert with NIGEL CALDERjun 202648V or 24V - What makes more sense on a Boat? | Ask The Expert with NIGEL CALDERjun 2026

De BoatHowTo — mira el barco del canal, la tripulación y cada vídeo analizado.