BoatHowTo · vidéo

Ce que couvre cette vidéo

Wiring a bow thruster and a windlass to the same 24-volt battery bank requires separate circuits for each device to ensure proper circuit protection. While both systems can share a common power source, they must not share a single circuit breaker.0:35 A 65-foot sailboat with a 700-amp bow thruster load requires heavy-gauge cabling, such as 4-0 (120 mm²) wire, paired with a 500-amp slow-blow fuse.0:56 This fuse rating allows for short-duration, high-amperage bursts without nuisance tripping.2:21 Nigel Calder notes that some voltage drop in these high-current circuits is beneficial, as it helps suppress arcing on solenoid contacts.2:59 Without this suppression, solenoid points can weld shut, causing the thruster to run continuously.3:24 If an emergency battery switch must be used to kill power under full load, the switch contacts will likely sustain damage and require replacement.4:06 Proper installation requires independent circuit protection for each high-draw component to maintain system reliability.

Plus de vidéos de BoatHowTo

Boat ELECTRIC PROPULSION with only LEAD ACID Batteries ?? | Ask The Expert with NIGEL CALDERsept. 2026MaxProp: More Pitch in Reverse than in Forward? 🤔 | Ask The Expert with NIGEL CALDERsept. 2026Common Ground Point with Isolated Saildrives | Ask The Expert with NIGEL CALDERsept. 2026How to keep you TANK CLEAN in the days of BIODIESEL.. | Ask The Expert with NIGEL CALDERaoût 2026

De BoatHowTo — voir le bateau, l'équipage et chaque vidéo analysée de la chaîne.

The Sailing Directory Newsletter

Un e-mail avec les meilleures trouvailles de la flotte — les moments, les bateaux et les histoires qui valent la peine d'être regardés. Entrez votre adresse pour recevoir votre propre exemplaire.