Living For Sail · vidéo

Ce que couvre cette vidéo

To restore the cockpit sole of a Liberty 458, the owner replaces the center core with 1-inch Kusa panels, securing them with epoxy and vacuum bagging to ensure a flat, void-free bond. To mount the binnacle, he designs and 3D-prints a custom vacuum-powered drill jig using a Prusa Core 1 printer and PLA filament. The jig features a vacuum port and 1/16-inch neoprene tape to create a seal, allowing the jig to hold firmly to the fiberglass surface under 25 inches of mercury. This setup enables precise drilling of the main binnacle hole and four mounting bolt holes. He further uses a 3D-printed guide to hold a 3/4-inch router bit, cleaning the hole bottoms to accept G10 backing plates. These G10 plates provide a hard mounting surface beneath the future Permateek decking, preventing compression of the synthetic teak under the binnacle's load. 3D-printed vacuum jigs provide a repeatable, accurate method for drilling and routing hardware mounting points on complex boat surfaces.

Bateaux dans cette vidéo

Plus de vidéos de Living For Sail

BACK to Work on ANTIDOTE! - How I Used 3D Printing to Fix My Boataoût 2026⛵️ I Tried Boiling Water Out of My Boat... It Actually Worked - sort of?!juil. 2026⛵️ This DIY Sailboat Repair Has To Work... Right?juin 2026Uh oh... 2 Reasons why there is No New Video Today...mai 2026

De Living For Sail — voir le bateau, l'équipage et chaque vidéo analysée de la chaîne.

The Sailing Directory Newsletter

Un e-mail avec les meilleures trouvailles de la flotte — les moments, les bateaux et les histoires qui valent la peine d'être regardés. Entrez votre adresse pour recevoir votre propre exemplaire.