Plus
Langue
Mode d'affichage
1 février 2026 · 11 min · 400 vues · Southwest Australia
Ce que couvre cette vidéo
Performing an oil change on a Yanmar 4JH57 marine diesel engine requires removing cockpit steps and engine panels to access the dipstick, which is positioned lower than on the previous 4JH4AE model.▶ 1:11 To prepare, run the engine for several minutes to warm the oil, then use an infrared heat sensor to confirm the temperature reaches approximately 44 degrees Celsius.▶ 2:47 A manual vacuum pump extracts the oil through the dipstick tube; if the pump loses suction, verify the hose connection and continue pumping until the reservoir indicates roughly five liters have been removed.▶ 5:12 To minimize spills when removing the side-mounted oil filter, place absorbent mats underneath and use a Ziploc bag to catch the filter and residual oil as it unscrews.▶ 8:46 After installing the new filter, lubricate the gasket with fresh oil, tighten it three-quarters of a turn past contact, and refill the engine with five liters of oil.▶ 10:34 Running the engine briefly after the change allows for a final leak check and dipstick level verification.▶ 11:20
Plus de vidéos de Jeanne Socrates Sailing the World Solo
De Jeanne Socrates Sailing the World Solo — voir le bateau, l'équipage et chaque vidéo analysée de la chaîne.