Living For Sail · video

Cosa tratta questo video

Restoring discontinued ProFurl LC42 and N42 headsail furlers requires replacing internal bearings, seals, and snap rings with off-the-shelf components. Because the aluminum extrusions and castings are no longer manufactured, the rebuild focuses on the lower drum units and upper swivels. To disassemble, use a small pick to expose the seal, then drill two holes in the cover to extract it with screws and a slide hammer. Heating the aluminum housing in an oven to 250°F allows the bearings to be pressed out or tapped through without damaging the casing. Use carbon steel bearings rather than stainless, as stainless steel deforms under the high loads of a furling system. After cleaning, fill scratches in the aluminum with JB Weld and smooth with a file. During reassembly, use PVC pipe sections as custom bearing drivers to ensure even pressure and prevent side-loading. Lubricate with Tef-Gel to isolate metals and protect against water intrusion.

Barche in questo video

Altro da Living For Sail

Completing this repair BEFORE it’s TOO LATE!ott 2026Can I Save This Bronze Cleat? Sailboat Bulwark Rebuildset 2026This Was Inside The Boat!? — Should I Put It Back?set 2026BACK to Work on ANTIDOTE! - How I Used 3D Printing to Fix My Boatago 2026

Da Living For Sail — guarda la barca, l'equipaggio e ogni video analizzato del canale.

The Sailing Directory Newsletter

Una email con le migliori scoperte della flotta — i momenti, le barche e le storie che meritano il tuo tempo di visione. Inserisci il tuo indirizzo per riceverne una copia.