Sven Yrvind · video

Hva denne videoen dekker

Sven Yrvind installs smaller hatches on his small cruiser, replacing an earlier version that sat too high.0:18 He sources nylock nuts from a hardware shop at Gronitz, directly across the street from where he is working — a convenience he notes given the boat's compact scale.1:09 A subscriber suggested using nylon line to prevent losing the small fasteners, and Yrvind adopts the idea, threading nylon through or around the hardware as a retention measure.2:17 He uses stainless-steel fasteners throughout but flags the risk of galling when stainless runs against stainless, countering it by lubricating the threads with molybdenum disulfide and tightening slowly.2:46 He also pairs nylock nuts against each other for double-locking.3:47 A hole drilled for a retaining line is planned but not yet complete by the end of the video.2:58 The practical takeaway: molybdenum disulfide lubrication and slow installation reduce galling risk when stainless fasteners thread into stainless fittings.

Mer fra Sven Yrvind

Four Sheets of Divinycell for the Hull Sides – I Think That's Enough.okt. 2026Nervously Cutting the Divinycell Sheets.okt. 2026Trying to Get the Sheerline Right.okt. 2026More molds up.okt. 2026

Fra Sven Yrvind – se kanalens båt, mannskap og alle analyserte videoer.

The Sailing Directory Newsletter

Én e-post med flåtens beste funn – øyeblikkene, båtene og historiene som er verdt din seertid. Skriv inn din egen adresse for å få din egen kopi.