Sven Yrvind · vídeo

Qué cubre este vídeo

Sven Yrvind installs smaller hatches on his small cruiser, replacing an earlier version that sat too high.▶ 0:18 He sources nylock nuts from a hardware shop at Gronitz, directly across the street from where he is working — a convenience he notes given the boat's compact scale.▶ 1:09 A subscriber suggested using nylon line to prevent losing the small fasteners, and Yrvind adopts the idea, threading nylon through or around the hardware as a retention measure.▶ 2:17 He uses stainless-steel fasteners throughout but flags the risk of galling when stainless runs against stainless, countering it by lubricating the threads with molybdenum disulfide and tightening slowly.▶ 2:46 He also pairs nylock nuts against each other for double-locking.▶ 3:47 A hole drilled for a retaining line is planned but not yet complete by the end of the transcript.▶ 2:58 The practical takeaway: molybdenum disulfide lubrication and slow installation reduce galling risk when stainless fasteners thread into stainless fittings.

Más de Sven Yrvind

Kai the bow paddle.jul 2026About safety.jul 2026My solution to crossing the Doldrums without using an engine.jul 2026Goose Barnacles Remower.jul 2026

De Sven Yrvind — mira el barco del canal, la tripulación y cada vídeo analizado.