Mer
SprÄk
Visningsmodus
BoatHowTovideo
26. juni 2026 · 2 min · 840 visninger
Nigel Calder explains battery switch positions on a boat
Hva denne videoen dekker
Nigel Calder addresses whether a pontoon boat owner can charge a starter battery and a house battery in parallel through a Perco 1-2-both switch by connecting a charger to one battery.â¶ 0:20 Theoretically, parallel charging of batteries with different CCA and amp-hour ratings is wrong, but Calder explains it works in practice because a cranking battery stays near full charge â engine cranking draws only a brief burst of current, quickly replaced by the alternator.â¶ 0:46 The house battery absorbs most of the charging current, so the charger should connect to the house battery, not the starter.â¶ 1:07 The parallel switch can then top off the cranking battery without significant damage, though it may shorten that battery's life.â¶ 1:46 The critical risk: leaving the switch in the parallel position drains both batteries, eliminating starting power.â¶ 1:46 Jan Attenstedt recommends a dual-output charger with a dedicated ~3-amp starter-battery output as a cleaner alternative for around $100, removing the need to remember switching discipline.â¶ 1:55 The practical takeaway is that the 1-2-both method is a workable, low-cost solution on small boats, but a two-output charger eliminates the main failure mode.
Mer fra BoatHowTo
Fra BoatHowTo â se kanalens bĂ„t, mannskap og alle analyserte videoer.