Project Brupeg · video

Hva denne videoen dekker

Replacing steel hull panels on a former fishing trawler requires precise alignment and a three-pass welding technique to ensure structural integrity. To fit a new 6mm steel plate, the crew cuts a 1mm gap around the perimeter, using a 1mm grinding disc to trim both the hull and the plate simultaneously. Because welding causes thermal expansion, the plate must not be tight against the hull to prevent cracking. The crew uses custom-fabricated "dogs"—small steel brackets with wedges—to pull the plate flush with the hull before tack welding. For the final join, they bevel the edges of both the plate and the hull to create a V-groove, then perform a root run followed by two cap runs on both the inside and outside of the hull. This multi-pass method provides redundancy if one weld fails. To mitigate fire risks from hot slag during welding, the crew places wet rags along the hull edges.

Mer fra Project Brupeg

What caused the steering to fail - Project Brupeg Ep.463okt. 2026CHAOS! & our first Night Time Trailer Haul Out - Project Brupeg Ep.462sep. 2026Look, It's possible we should have cleaned this before now... Project Brupeg Ep.461sep. 2026The Ridiculously Powerful Davit Winch - Project Brupeg Ep.460sep. 2026

Fra Project Brupeg – se kanalens båt, mannskap og alle analyserte videoer.

The Sailing Directory Newsletter

Én e-post med flåtens beste funn – øyeblikkene, båtene og historiene som er verdt din seertid. Skriv inn din egen adresse for å få din egen kopi.